User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
Oscillator
MRX Designer User Guide
98
❑ Oscillator
The MRX provides a mono channel oscillator.
“Oscillator” component editor
Here you can specify the generated waveform and its level.
1 OSCILLATOR [ON] button
Specifies whether the specified signal is output.
2 [100Hz]/[1kHz]/[10kHz] buttons
These buttons output a sine wave of the corresponding frequency.
3 [VARI] button / [Freq.] knob
If this button is on, a sine wave of the frequency specified by the knob is output.
If you want to use this as a pilot tone, mix it immediately after YDIF OUT or DANTE
OUT.
4 [Pink] button
Outputs pink noise.
5 [Burst] button
Outputs burst noise.
6 [LEVEL] knob
Specifies the output level.
7 Meter
Shows the level of the signal that is being output.
1
7
6
4
5
2
3