User Manual
Main screen
Yamaha LAN Monitor User Guide
NOTE
For more about transmit flow and receive flow, and unicast and multicast, visit the following Yamaha Pro Audio site, navigate
to [Training & Support] [Self Training] [Dante Network Design Guide], and refer to [Multicast Settings].
http://www.yamaha.com/proaudio/
4 [Dante Controller] button
You can click this to start Dante Controller and configure Dante settings, such as patching. If Dante Controller is
not installed, an error message appears.
For details on using Dante Controller, refer to the Dante Controller User Guide.
5 [Device Settings] button
This shows the “Device Settings” dialog box.
Use this to update label settings, IP address settings and Yamaha switch firmware.
Either “IP address settings” or “Update firmware from PC” will appear depending on the device in use.
NOTE
“IP address settings” and [Update firmware from PC] button may not appear depending on the device in use.
Shows the sampling frequency, bit-length, and latency of the audio signal. The latency is
shown in μ second units.
Shows the sampling rate pull-up/pull-down setting.
Lit in red when the Dante-enabled device is muted.
Shows information about Dante transmission and reception.
Shows the current amount of transmission and reception in kbps units.
Shows the number of errors that occurred during transmission and reception. The
[Clear] button located at the right resets the indication of the [Errors] field to 0.
Shows the status of the Dante “Primary” port and “Secondary” port.
The link speed is shown inside the graphic of the port.
The setting of the Dante “Secondary” port is shown below the
graphic of the ports.
Turns the snapshot function on/off for each device. For a slave device, this is fixed on.
Allows you to freely enter a label and comment to distinguish the individual unit.
Click the [Settings] button to display the “IP address settings” dialog box.
Click the [Update firmware from PC] button to display the “Update firmware from PC”
dialog box.
When you click this, the “Device Settings” dialog box closes.