User Manual
Table Of Contents
- 数据版权相关注意事项
- 本使用说明书内容相关的注意事项
- 目录
- 第1章MTX-MRX Editor概述
- 第2章菜单栏和工具按钮
- 第3章Project画面
- 第4章系统画面
- 第5章联机和同步
- 第6章预设设定
- 第7章对话框/软件应用程序
- “Startup” 对话框
- “Network Setup”对话框
- “Device Information”对话框
- “Match Devices by IP Address”对话框
- “MTX Configuration”对话框
- “Dante Information”对话框
- “Word Clock”对话框
- “Clock”对话框
- “Daylight Saving Time”对话框
- “Scheduler”对话框
- “Remote Control”对话框
- “External Events”对话框
- “Digital Control Panel”对话框
- “Wireless DCP”对话框
- “MCP1”对话框
- “PIN Setup”对话框
- “Label”对话框
- “Re-size Image”对话框
- “PGM1/PGX1”对话框
- “PGM1 Label Creator”应用程序
- “GPI”对话框
- “GPI Calibration”对话框
- “Security Settings”对话框
- “Project Information”对话框
- “Configuration Diagram”对话框
- “Get Log”对话框
- “Sampling Rate Converter”对话框
- “Input Source/Redundant”对话框
- 附录
MTX-MRX Editor 用户指南
161
第 7 章对话框 / 软件应用程序
本章节介绍可以从菜单栏或工具栏打开的对话框和应用程序。
❑“Startup” 对话框
启动 MTX-MRX Editor 时,将出现此对话框。
● [New file] 选项按钮
单击 [OK] 按钮时,将出现“Device Configuration Wizard”对话框。
● [Existing file on computer] 选项按钮
单击 [OK] 按钮时,将打开所选文件。如果已分配 PIN 码,将要求您输入 PIN
码。
● [Go online – From devices] 选项按钮
单击 [OK] 按钮时,将从网络中当前正在运行的 MTX/MRX 设备中载入 MTX/
MRX 系统设定,从而创建一个项目文件。
若要载入设定,必须连接之前与 MTX-MRX Editor“联机”的 MTX/MRX 设备。
如果已为设备分配 PIN 码,将要求您输入 PIN 码。
● [OK] 按钮
执行选项按钮所选的操作。