User Manual
Table Of Contents
- 数据版权相关注意事项
- 本使用说明书内容相关的注意事项
- 目录
- 第1章MTX-MRX Editor概述
- 第2章菜单栏和工具按钮
- 第3章Project画面
- 第4章系统画面
- 第5章联机和同步
- 第6章预设设定
- 第7章对话框/软件应用程序
- “Startup” 对话框
- “Network Setup”对话框
- “Device Information”对话框
- “Match Devices by IP Address”对话框
- “MTX Configuration”对话框
- “Dante Information”对话框
- “Word Clock”对话框
- “Clock”对话框
- “Daylight Saving Time”对话框
- “Scheduler”对话框
- “Remote Control”对话框
- “External Events”对话框
- “Digital Control Panel”对话框
- “Wireless DCP”对话框
- “MCP1”对话框
- “PIN Setup”对话框
- “Label”对话框
- “Re-size Image”对话框
- “PGM1/PGX1”对话框
- “PGM1 Label Creator”应用程序
- “GPI”对话框
- “GPI Calibration”对话框
- “Security Settings”对话框
- “Project Information”对话框
- “Configuration Diagram”对话框
- “Get Log”对话框
- “Sampling Rate Converter”对话框
- “Input Source/Redundant”对话框
- 附录
本使用说明书中使用的术语 第 1 章 MTX-MRX Editor 概述
MTX-MRX Editor 用户指南
5
●紧急模式
如果“Preset”对话框的 [Emergency Recall] 设定为 [ON],当接收到外接设备的
EMG(紧急)信号或当输入到 +24V [GPI IN] 针脚(MTX3 为 IN 8,MTX5-D 和
MRX7-D 为 IN 16)的电压低于 2.5V 时,MTX/MRX 将进入此模式。在此模式中,
本设备将按照如下所示工作。
• 当前状态将被记忆。此记忆状态用于当本设备退出紧急模式时返回到原始
状态。
• 将调用“Preset”对话框的 [Emergency Recall] 设定中指定的预设设定。
• 将不再接收来自 DCP 等外接控制器的操作。(在 MCP1 上,只能操作工具
页面。)
• 如果在“PGM1/PGX1”对话框中选择 [All broadcast will be stopped.],包 括
调度程序在内的整个寻呼系统将停止。
• 本设备将从 MTX-MRX Editor 脱机。
• 同一 MTX/MRX 系统中的所有 MTX/MRX 设备将进入紧急模式。