User Manual
Table Of Contents
- ■ Precautions (Please be sure to read this section first!)
- ■ Checking the version number
- ■ Preparing for the update
- ■ Update procedure sequence
- ■ Decompressing the downloaded file
- ■ Install the MTX-MRX Editor
- ■ Install the Dante Firmware Update Manager (for Dante)
- ■ Computer TCP/IP setting (for Dante)
- ■ Updating the Dante firmware
- ■ Computer TCP/IP setting ( for device main)
- ■ Updating the device main firmware
- ■ About Failsafe Mode
4
■ Update procedure sequence
Update each firmware component in the following sequence. If you're using a YDIF model, execute the
colored steps. If you're using a Dante model, execute all of the steps. However if there's no need to
update the Dante firmware, execute only the colored steps even if you're using a Dante model.
Decompressing the downloaded file
Install the MTX-MRX Editor
Install the Dante Firmware Update Manager
(for Dante)
Computer TCP/IP setting (for Dante)
Updating the Dante firmware
Computer TCP/IP setting (for device main)
Updating the device main firmware
If there are 2 computers, you may use one for device firmware update and the other for Dante
firmware update so that you can perform the work without switching the TCP/IP settings.