User Manual

“I/O” screen Chapter 4. System screen
MTX-MRX Editor User Guide
112
“I/O” screen
In this screen you can make settings related to the HA (head amp) of the MTX’s analog input, and for
the MTX’s digital output.
You can also make settings to specify whether a pilot tone is output from digital output.
When the PILOT TONE [ON] button is on, a pilot tone is output to channels whose digital output’s
[PT] button is on.
To specify the XMV units that receive the pilot tone, access the “Project” screen > [Device] tab, and
click the [INPUT SOURCE] button to make settings for redundancy.
Signal flow
1
2
3
45
INPUT
1-8
+48V
AD
+
-
+48V
GAIN
ME TER
INPUT
8
16
16
YDIF MODE
CASCADE MODE
or DISTRIBUTION MODE
YDIF
OUT
PILOT TONE
ON
LEVEL
Sine Wave
20.0kHz
To YDIF OUT
To DANT E O UT
From PILO T TONE
SUM
16
DANTE
OUTPUT
GAIN
POL A RITY
SUM
From PILO T TONE
16