User Manual

“EXi8 Patch” dialog box Chapter 4. System screen
MTX-MRX Editor User Guide
131
5 [Ø] button
Switches the phase of the input signal.
6 [ON] button
Switches the input channel on/off.
The button also shows the on/off status.
7 [HPF] button/Cutoff frequency
The [HPF] button switches the HPF (High Pass Filter) on/off.
The cutoff frequency is shown below the [HPF] button.
You can double-click the cutoff frequency to edit it.
8 HA analog gain
Shows the HA analog gain setting.
You can double-click this and edit it.
9 Channel name
Indicates the channel name.
You can double-click this and edit it.
0 Output routing select button
This button opens the “EXi Patch” dialog box, where you can select the output
destination channels for the audio signal.
To enable this button, click the [EDIT] button.
❑ “EXi8 Patch” dialog box
Here you can select the output destination channels for the audio signals of the EXi8 unit.
1 [YDIF] buttons
Select the output destination channels.
2 [Close] button
Closes the “EXi8 Patch” dialog box.