User Manual

“R/Tio” screen Chapter 4. System screen

MTX-MRX Editor User Guide

132

“R/Tio” screen

Here you can view and edit the parameters for the analog input jacks of an R series (AD/DA) or

Tio1608-D unit. When you right-click on the display area of a desired R series (AD/DA) or Tio1608-

D, a context menu appears, allowing you to copy and paste settings between devices.

Since the Ro8-D has no analog input jacks, it is not shown.

1 Device identification field

Shows the DEVICE NAME that is specified in the [Device] tab of the “Project” screen.

2 “+48V MASTER” indicator

Indicates the on/off status of the device’s master phantom power.

3 [PEAK HOLD] button

If this button is on, the peaks of each level meter are held. When this button is turned

off, the held peaks are cleared.

4 Channel button

Indicates the [INPUT] jack number of the device. When you click this, the indicator of

the corresponding jack will flash for approximately five seconds, allowing you to

identify the jack.

5 Level meter

Shows the input signal level.

6 [+48V] button

Turns the HA phantom power (+48V) on/off. This is valid if the unit’s master phantom

power is on.

NOTE