User Manual

Synchronization Chapter 5. Online and Synchronization
MTX-MRX Editor User Guide
143
Synchronization
Synchronization includes the following three operations.
1) Synchronizing from the computer (MTX-MRX Editor) to the MTX/MRX unit itself
The settings (configuration and parameters) of MTX-MRX Editor are sent to the MTX/
MRX.
Use this method when you have prepared a file beforehand, and want to send those
settings to the MTX/MRX on-site.
In the “Synchronization” dialog box, choose [To Device].
2) Synchronizing from the MTX/MRX unit to the computer (MTX-MRX Editor)
•Case 1
The MTX/MRX’s parameters are loaded into MTX-MRX Editor. Use this method
when a DCP or Wireless DCP has been used to modify the settings of the MTX/MRX
unit, and you want to go back online to modify or view these changes.
Choose [From Device] in the “Synchronization” dialog box.
Synchronization is not possible if there are differences between the MRX unit and
MTX-MRX Editor’s component type or cabling between components.
Parameters
Configuration
Computer
Overwrite parameters
Overwrite configuration
MTX/MRX
NOTE
Overwrite parameters
Configuration
Computer
Parameters
Configuration
MTX/MRX