User Manual

“Settings” dialog box Chapter 6. Presets
MTX-MRX Editor User Guide
153
If [Active] is specified
When [OUTPUT TYPE] is [ Closed], the [GPI OUT] pin will be closed
(connected to ground).
When [OUTPUT TYPE] is [ Open], the [GPI OUT] pin will be open.
When [OUTPUT TYPE] is [ Pulse], the [GPI OUT] pin will be closed (connected
to ground) for approximately 250 ms.
When [OUTPUT TYPE] is [ Pulse Inv.], the [GPI OUT] pin will be open for
approximately 250 ms.
If [Inactive] is specified
When [OUTPUT TYPE] is [ Closed], the [GPI OUT] pin will be open.
When [OUTPUT TYPE] is [ Open], the [GPI OUT] pin will be closed (connected
to ground).
If [Ignore] is specified
There will be no change in the output. Use this setting if a different function is
assigned to GPI OUT and you don’t want that function to be affected by preset recall.
If the GPI “Settings (Output Port)” dialog box [OUTPUT TYPE] is set to [ Closed] or
[ Open], and you then specify [Inactive], it will automatically be changed to [Ignore]
if you switch to [ Pulse]/[ Pulse Inv.].
• [OK] button
Saves the settings and closes the dialog box.
•[Cancel] button
Closes the dialog box without saving the changes.
“Settings (Output Port)” dialog box for “GPI”
[OUTPUT TYPE]
NOTE