User Manual

“IP Address” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
170
“IP Address” dialog box
Here you can set the device’s IP settings.
As the device’s settings, we recommend that you set “IP SETTINGS” to “UNIT ID” or
“STATIC IP (Auto),” and set the computer’s IP address to “192.168.0.253” and its subnet
mask to “255.255.255.0.”
Editing is not possible while online.
In order to use MTX-MRX Editor to control MTX/MRX systems of differing subnets, it is
necessary to operate the devices using unique IP addresses. For details, refer to “Settings
for controlling devices across subnets”.
If a PIN code has been assigned, you will be asked to enter the PIN code. Devices whose
PIN could not be unlocked do not appear in the device list, and their settings cannot be
edited.
If you want to fix the device’s IP address and subnet mask, make the following settings in
this dialog box.
1. Set the computer’s IP address to “192.168.0.253” and the subnet mask
to “255.255.255.0”.
2. As the device’s settings, set “IP SETTINGS” to “UNIT ID” or “STATIC (IP)
(Auto),” set the UNIT ID of all devices to something other than FD so
that none of the devices conflict, and then power-on the devices.
3. From the list in the left of the “IP Address” dialog box, select the device
that you want to edit.
4. In the “IP Address” dialog box, select the [Use the following IP Address]
option button (specify a fixed IP address for the device).
5. Specify values for [IP Address] and [Subnet Mask].
6. Click the [OK] button.
7. As the device’s setting, specify either PC mode or STATIC IP (MANUAL).
8. Power-off the device, wait about ten seconds, and then turn the power
on.
NOTE