User Manual

“MTX Configuration” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
177
❑ “MTX Configuration” dialog box
Here you can specify input/output settings for each device, such as MTX/MRX input ports, output
channels, and matrix buses.
Since these settings are not included in a preset, they cannot be changed via the Preset
Recall function.
● Device:
Selects an MTX unit within the MTX/MRX system.
From the left, this shows the “UNIT ID,” “Type (model name of the device),” and
“Device Name (name of the device).”
● [Advanced Settings] button
The “Advanced Settings” dialog box will appear.
● [OK] button
Saves the settings and closes the dialog box.
● [Cancel] button
Discards the settings and closes the dialog box.
● [INPUT] tab
In this tab, you can make settings related to inputs.
• INPUT PORT SETUP
Here you can specify the inputs to the stereo input ports.
STEREO .................The stereo signal will be input without change.
SUM ........................The L and R inputs will be summed to a single channel.
There will be one input to the input patch.
• INPUT CHANNEL SETUP
Here you can make settings for the input channels. The settings here will affect the
input channel strip of the “MAIN” screen.
MONO x2...............The input channels will be treated as two monaural channels.
STEREO .................The input channels will be treated as a single stereo pair.
NOTE