User Manual

“Digital Control Panel” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
204
• [LED Brightness] box
Specifies the brightness of the DCP unit’s LEDs. Higher values will make the LEDs
brighter.
• [Enable Inactive Mode] check box
If the check box is selected, the unit automatically enters inactive mode after a time
duration specified in [Waiting Time].
[Inactive LED Brightness] specifies the brightness of the LEDs when inactive.
If the check box is cleared, the drop-down menu is grayed-out and you will be unable
to set the brightness.
• [Panel Lock] check box
If this check box is selected, the DCP panel will be locked when the preset library is
recalled.
If the [Enable Temporary Unlocking] check box is selected, pressing and holding
down DCP switch 1 for two seconds will unlock the panel.
•[Waiting Time]
Specifies the time from the last operation until the unit enters inactive mode or the
panel is locked.
● Menu button ( )
Click this button to execute the following functions.
•[Copy]
Copies the Parameter Assign, Dimmer & Lock, and Source Select of the displayed
DCP to the copy buffer.
•[Paste]
Overwrites the Parameter Assign, Dimmer & Lock, and Source Select settings of the
same model from the copy buffer onto the displayed DCP.
It is only possible to paste settings that were copied within the same MTX/MRX
system.
• [Initialize]
Initializes the Parameter Assign, Dimmer & Lock, and Source Select settings of the
displayed DCP.
• [Clear [Parameter Assign]]
Initializes the Parameter Assign settings of the displayed DCP.
● [Close] button
Closes the dialog box.