User Manual

“MCP1” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
208
❑ “MCP1” dialog box
Up to 16 MCP1 units can be connected to one MTX/MRX system.
Using Ethernet cables, connect the MTX/MRX unit’s [NETWORK] port or Dante port to a PoE
network switch, and connect the PoE network switch to the MCP1.
If the network switch does not support PoE, connect a PoE injector between the network switch and
the MCP1.
Some PSE units (PoE network switches or PoE injectors) might have some ports that supply power
and other ports that do not supply power. Connect the MCP1 to a port that supplies power.
In this dialog box you can make settings for the MCP1’s L1/2/3 and R1/2/3 switches and display.
You can store 8 sets of MCP1 settings in the Library. You can also associate library items
with presets for recall.
After editing in a tab such as [Home]/[Page 1]–[Page 6]/[Dimmer & Lock]/[Source
Select], click the item in the [Library] list to which you want to save, and then click the
[Save] button to save the item to the library.
In the [Library] list, click the library item that you want to load, and then click the [Load]
button to load the library item; the settings will be applied to tabs such as [Home]/[Page
1]–[Page 6]/[Dimmer & Lock]/[Source Select].
• If you associate a saved library item with a preset, the parameter assignments of [HOME]
and [Page 1] through [Page 6] for all MCP1 units (up to 16 units) connected to the MTX/
MRX system will be recalled/stored in a single action when you recall that preset. If you want
to recall only a specific MCP1 unit, open the “Preset” dialog box and make [Recall Filter]
settings.
• You must use the “Device Configuration Wizard” dialog box to assign the MTX/MRX and
MCP1 units and specify their ID settings beforehand. If you have not made these settings
yet, you won’t be able to open the “MCP1” dialog box; an alert will be displayed.
• The [Source Select] tab is shown if there is an MRX unit in the MTX/MRX system. For details,
refer to “MRX Designer User Guide.”
● MCP1 select list box
Select the MCP1 unit for which you want to make settings. All MCP1 units that are
connected to the MTX/MRX system are listed in order of UNIT ID and the name of the
MCP1 unit.
● [PIN Setup] button
This button shows the “PIN Setup” dialog boxwhere you can specify three types of PIN.
NOTE