User Manual

“PGM1/PGX1” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
220
● [Properties] tab
Here you can make settings for the operation of the PCM1.
• [Stop all broadcast.] option button
If this is selected, paging broadcast including the scheduler will be stopped when the
MTX/MRX system is in emergency mode.
• [Stop broadcast except for 1st Priority PGM1] option button
If this is selected, paging broadcast will be possible only for the 1st Priority PGM1
when the MTX/MRX system is in emergency mode.
• [Opening Chime]/[Closing Chime] check boxes
If these check boxes are selected, you can make settings for the opening chime and/
or closing chime. Click the button at right to specify the chime file that will play. This
setting is shared by the PGM1 (Paging Device Group) units that are connected to the
same MTX/MRX.
• [Maximum paging duration] list box
Selects the time after PTT is turned on until it is automatically turned off. If a
message is being played back, it will not turn off even if the specified time is
exceeded. This setting is shared by the PGM1 units that are connected to the same
MTX/MRX.
• [The scheduler’s paging events are broadcast with higher priority than PGM1.
Paging events have a lower priority than 1st Priority PGM1.] check box
If this check box is selected, the priority order will be “1st Priority PGM1 > events >
normal PGM1.” If this check box is cleared, the priority order will be “1st Priority
PGM1 > normal PGM1 > events.”
● [Label Creator] button
Click this button to start the “PGM1 Label Creator” application.
● [OK] button
Saves the settings and closes the dialog box.
● [Cancel] button
Discards the settings and closes the dialog box.