User Manual

MTX-MRX Editor User Guide
235
Appendix
List of settings in “Settings” dialog boxes
This section explains the settings in the following “Settings” dialog boxes.
For details about settings that are unique to the MRX series, refer to “MRX Designer User Guide.”
• DCP/Wireless DCP/MCP1
•GPI Input
• GPI Output
■ DCP/Wireless DCP/MCP1
Settings for the switches and knobs/sliders of the DCP, the Wireless DCP, or MCP1 are
explained here.
● If [FUNCTION] is [No Assign]
Use this setting if you don’t want the switch or the knob/slider of the controller to
change any setting. This is unavailable for [DEVICE] and for [PARAMETER 1/2].
● If [FUNCTION] is [Open Page] (only for the HOME page of the MCP1)
The switch of the MCP1 changes pages of the MCP1.
● If [FUNCTION] is [MTX ON] (switch only)
The switch turns the parameter on/off.
Select one of the following parameter types, and then make the appropriate setting.
•Input Ch ON
•Fx RTN ON
• ZONE Out ON
•Output Ch ON
• Input Ch Mute Group
•ZONE Out Mute Group
In the case of Input Ch Mute Group and ZONE Out Mute Group, the unit’s LED is unlit when
mute is on.
NOTE