User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
248
●If [FUNCTION] is [Legacy - MTX Source Select w/knob]
(only for switches of a DCP equipped with knobs)
You can control the send on/off for multiple channels via switches, and control the send
level for any channel via knobs.
If you assign the same source to multiple DCP units and then change the settings on
one of the DCP units, the changes will not be updated on other DCP units. Each DCP
unit will retain the settings (LED status and knob assignments) that were made on it.
❍ [DEVICE]
Select the device that you want to change. These are listed in order of UNIT ID and
model name.
❍ [PARAMETER1]/[PARAMETER2]
In the [PARAMETER1] column, select the target ZONE.
In the [PARAMETER2] column, click  to the left of the channel name to select
ON, OFF, or IGNORE for the desired channels. The ON/OFF/IGNORE setting can
be applied to multiple channels simultaneously. If you select an ON channel, the
bottom half of the dialog box will display parameter fields related to the knobs.
❍ [Assign the send level to:] box
Enables you to select a knob that will control the send level of the currently-selected
channel.
Only one channel can be assigned to a knob.
❍ [Parameter Range]/[Nominal]/[Knob]
Enable you to make a setting for the knob that has been specified in the [Assign the
send level to:] box. For details about the settings, refer to If [FUNCTION] is [MTX
Level] for knobs/sliders.
NOTE