User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
260
●If [FUNCTION] is [MTX ON]
Parameter on/off operations on the specified device will control the GPI Output.
Select one of the following parameter types, and then make the appropriate setting.
•Input Ch ON
•Fx RTN ON
• ZONE Out ON
•Output Ch ON
• Input Ch Mute Group
•ZONE Out Mute Group
❍ [DEVICE]
Select the device that you want to change.
❍ [PARAMETER1]
Specifies the channel whose on/off operations will control the [GPI OUT}
connector.
❍ [OUTPUT TYPE]
Specifies how output will occur from the [GPI OUT] connector.
❍ [Threshold]
Indicates the threshold value of the parameter. This is fixed at 0.5.
❍ [Direction]
Specifies the direction of change for the parameter that will control the [GPI OUT]
connector. This is shown if [OUTPUT TYPE] is set to [Pulse] or [Pulse Inv.].
● If [FUNCTION] is [MTX Send Level]
Controls the GPI Output according to the send level (volume changes) of each channel.
You can use this to fader-start a CD player, or to light an indicator when high volume
occurs. Select one of the following parameter types, and then make the appropriate
setting.
•Input Ch Send Level
•Fx RTN Send Level
For details on these settings, refer to If [FUNCTION] is [MTX Level].
● If [FUNCTION] is [MTX Send ON]
Send on/off operations will control the GPI Output.
Select one of the following parameter types, and then make the appropriate setting.
•Input Ch Send ON
•Fx RTN Send ON
For details on these settings, refer to If [FUNCTION] is [MTX ON].
● If [FUNCTION] is [MTX Priority Ducker ON]
On/off operations of the zone’s Ducker will control the GPI Output.
Select one of the following parameter types, and then make the appropriate setting.
•1st Priority
•2nd Priority
For details on these settings, refer to If [FUNCTION] is [MTX Priority Ducker ON]
(switch only).