User Manual

Alert list Appendix
MTX-MRX Editor User Guide
272
202
The firmware update has been
completed.
–
Information Single
203
Initialization has been
executed.
–
Information Single
204
Panel lock has been disabled.
–
Information Single
205
The IP address has been
established.
–
Information Single
206
The network IP address has
been allocated from the DHCP
server.
–
Information Single
207
The network IP address has
been released by the DHCP
server.
–
Information Single
208
An EMG (Emergency) signal
was received, and the device
switched to EMG mode.
–
Information Continuing
209
The setting of the internal clock
has been changed.
–
Information Single
210
The event has been executed
using the scheduler.
–
Information Single
211
MTX-MRX Editor began
synchronisation.
–
Information Single
213
A login failure has occurred
from an external remote
controller via the remote control
protocol.
–
Information Single
214
A login authentication has been
successfully completed from an
external remote controller via
the remote control protocol.
–
Information Single
215
The SD memory card has been
mounted properly.
–
Information Single
216
The SD memory card was
removed while the MTX was
turned on.
–
Information Single
217
Preset number ** was recalled.
–
Information Single
218
Preset number ** was stored.
–
Information Single
220
The clock has been
successfully synchronized by
the time server.
–
Information Single
221
Preset number ** was edited.
–
Information Single
222
A snapshot/snapshot group
was recalled.
–
Information Single
223
Snapshot was stored.
–
Information Single
224
Snapshot was edited.
–
Information Single
225
Snapshot group was edited.
–
Information Single
Number Content Action Type
Single/
Continuing