User Manual

“Device Configuration Wizard” dialog box Chapter 3. Project screen

MTX-MRX Editor User Guide

3. Specify the type and number of devices that will be assigned to the

MTX/MRX system.

Determine the number of devices that will be connected via cable, other than digital

control panels.

If you selected [Edit Configuration] in the first screen of the wizard, the currently-

assigned number of devices is shown. In this case, it is not possible to change the

number of units to less than this number or to greater than Connection

requirements for an MTX/MRX system.

Devices whose number of units is set to 0 will be dimmed and unavailable.

On the Tio1608-D, the UNIT ID range is narrower. When using the Tio1608-D, avoid

using UNIT ID settings 01–0C for other devices in the next screen.

• [Number] box

Specifies the number of devices.

•[Cancel] button

Cancels the operation and exits the wizard.

• [< Back] button

This button will be dimmed and unavailable.

• [Next >] button

Applies the changes and proceeds to the next screen.

• [Finish] button

This button will be dimmed and unavailable.

NOTE