User Manual

[Device] tab Chapter 3. Project screen

MTX-MRX Editor User Guide

● [SLOT] (MTX5-D/MRX7-D only)

Indicates the Mini-YGDAI card specified in the “Device Configuration Wizard” dialog

box. The [SRC] button is shown if an MY4-AEC or MY8-AE96S is selected. Click this

to open the “Sampling Rate Converter” dialog box.

● [INPUT SOURCE] button (XMV only)

For each channel, this indicates whether the input is analog or digital. When you click

this, the “Input Source/Redundant” dialog box will appear. An “R” symbol is shown

beside a digital input that is specified as Redundant. The “R” symbol turns yellow if the

input has switched from digital to analog.

● [D.INPUT SENS.] (XMV only)

This specifies the input sensitivity from YDIF or Dante. If you select “–20 dBFS,” the

input sensitivity will be the same as the analog connectors.

If you change from [–3 dBFS] to [–20 dBFS], the output from the XMV will be louder for the

same attenuator value. If you want to change this, lower the level and attenuator value before

you make the change.

● [YDIF] indicator (YDIF-enabled models only)

When online, this indicator is lit green if the rear panel [YDIF IN] jack is correctly

connected to another device’s [YDIF OUT] jack.

● [SCHEDULER] indicator (MTX/MRX only)

When online, this indicator is lit yellow if an event has been set in the Scheduler, and

will flash one minute prior to the event.

● [SD/ACT] indicator (MTX/MRX only)

When online, this indicator is lit yellow if an SD memory card is inserted into the SD

memory card slot and is recognized correctly. The indicator will flash if the unit is

accessing the SD memory card.

● [DISABLE SYNC LEDS] (MTX/MRX/XMV Dante-enabled models only)

If you click the [ON] button to make it light, the [SYNC] indicator of the device will no

longer light. When you click the [ON] button once again to turn it off, the indicator will

be able to light.

NOTE