User Manual

Input channels Chapter 4. System screen

MTX-MRX Editor User Guide

Parameter edit screen (for the EXi8)

A Meter

Shows the input signal level.

B [+48V] button

Turns the HA phantom power (+48V) on/off.

Notice

Be sure to leave this button off if you do not need phantom power.

Follow the important precautions below, in order to prevent noise

and possible damage to external devices as well as the unit when

you operate this switch.

• Be sure to leave this button off when you connect a device that

does not support phantom power to [INPUT] connector.

• Do not connect/disconnect a cable to/from [INPUT] connector

while this button is on.

• Down the output level to the minimum before operating this

button.

There is no master switch. To avoid malfunctions, be sure to set

this appropriately for the equipment that is connected.

C [GAIN] knob

Adjusts the analog gain of the HA (head amp)

D HA analog gain

Shows the HA analog gain setting.

E [HPF] button

Switches the HPF (High Pass Filter) on/off.

F [Freq] knob

Specifies the cutoff frequency of the HPF.

G Cutoff frequency

Indicates the cutoff frequency of the HPF.

H [Ø] button

Switches the phase of the input signal.

I [ON] button

Switches the input channel on/off.

J Channel name

Indicates the channel name of the EXi8. You can double-click

this and edit it.

K Channel index

Indicates the number of the device’s input connector. If you

place the cursor here, a popup will show the UNIT ID and the

name of the external device.

NOTE