User Manual

Input channels Chapter 4. System screen
MTX-MRX Editor User Guide
64
Parameter edit screen (for the Tio1608-D)
A
C
B
D
E
F
G
H
A Meter
Shows the input signal level.
B [+48V] button
Turns the HA phantom power (+48V) on/off.
Notice
Be sure to leave this button off if you do not need phantom power.
When turning phantom power on, you must observe the
precautions below in order to prevent noise and possible damage
to the unit and to external devices.
• Leave this button off if a device that does not support phantom
power is connected to the [INPUT] connector.
• Do not connect/disconnect a cable to/from the [INPUT]
connector while this button is on.
• Lower the output level to the minimum before turning phantom
power on/off.
C [GAIN] knob
Adjusts the analog gain of the HA (head amp).
D HA analog gain
Shows the HA analog gain setting.
E [HPF] button
Switches the HPF (High Pass Filter) on/off.
F [Freq] knob
Specifies the cutoff frequency of the HPF.
G Cutoff frequency
Indicates the cutoff frequency of the HPF.
H Channel index
Indicates the number of the device’s input jack. If you place the
cursor here, a popup will show the UNIT ID and the name of
the external device.