User Manual

“Input Patch” dialog box Chapter 4. System screen

MTX-MRX Editor User Guide

❑ “Input Patch” dialog box

Here you can specify the connector or channel whose signal will be assigned to each input channel.

• [Input CH] box

Selects the input source channel.

•INPUT

These are the MTX’s [INPUT] connectors.

•ST IN

These are the MTX’s [ST IN] connectors.

•SD IN

This is the MTX’s SD memory card.

•YDIF

This is the MTX’s [YDIF] connector.

• DANTE (MTX5-D only)

This is the MTX5-D’s [Dante] connector.

•SLOT (MTX5-D only)

This is the MTX5-D’s [SLOT].

• AEC (MTX5-D only)

These are the signals processed by the MY4-AEC installed in the MTX5-D’s [SLOT].

These are not shown if the MY4-AEC is not installed. For details, refer to “MY4-

AEC Owner’s Manual.”

• OUTPUT CHANNEL (only for the MY4-AEC’s Near-end Mic. and From Far-end)

These are the MTX5-D’s output channels.

• [Close] button

Closes the “Input Patch” dialog box.