User Manual

14 MCP1 Installation Manual
Removal
If you need to remove the MCP1, insert a slotted screwdriver into the notches of the side
panel, and twist. The subsequent steps are the reverse of the installation procedure.
Initializing the MCP1
With the unit powered on, perform the following procedure.
1. In the home page or another page, long-touch (two seconds or longer) the home
page switch.
Move to the utility page.
2. Touch the [Settings] switch (R1).
After synchronizing with MTX-MRX Editor, it will be necessary to enter the PIN code.
3. Touch the [Initialize] switch (L3).
A confirmation screen appears; select Yes. Initialization begins, and the MCP1 automati-
cally restarts.
NOTE
When re-installing the MCP1, portions of the screw holes in the mount plate may be deformed and may not
properly fit into the MCP1. If this is the case, use a tool to adjust parts of the screw holes as necessary and
re-install the unit.
NOTE
If you have forgotten the PIN code, use MTX-MRX Editor to specify it again.