User Manual
Table Of Contents
9MCP1 Installation Manual
Connections with an MTX/MRX system
Up to 16 MCP1 units can be connected to an MTX/MRX system.
Use an Ethernet cable to connect the MTX/MRX’s [NETWORK] port or Dante port to a PoE
network switch, and use an Ethernet cable to connect the PoE network switch to the MCP1.
If the network switch does not support PoE, connect a PoE injector between the network
switch and the MCP1.
In some cases, the PSE (PoE network switch or PoE injector) might have ports that supply
power and ports that do not supply power. Connect the MCP1 to a port that supplies power.
For details on how to synchronize each device, refer to “MTX-MRX Editor User Guide.”
Connections for a small system
Connections for a large system
Computer
MTX3
SWR2100P-5G
MCP1
Maximum 100 meters
Computer
MRX7-D
SWR2100P-10G
MCP1
Maximum
100 meters
XMV8280-D
SWP1-16MMF
MCP1 MCP1 MCP1