User Manual

Controls and Connectors
MTX5-D Owner’s Manual
14
5. Plug the Euroblock plug into the [GPI] con-
nector or [INPUT]/[OUTPUT] connector of
the MTX5-D.
 Installing an option card
Before you install I/O cards in slots, you must check the
Yamaha website to determine whether the card is compatible
with the MTX5-D.
http://www.yamahaproaudio.com/
To install an optional Mini-YGDAI card, proceed as follows.
1. Make sure that the power is turned off.
2. Loosen the screws that hold the slot cover
in place, and remove the slot cover.
Keep the removed slot cover and screws in a safe place.
3. Align the edges of the card with the guide
rails inside the slot, and insert the card into
the slot.
Push the card all the way into the slot so that the connec-
tor at the end of the card is correctly inserted into the con-
nector inside the slot.
4. Use the screws included with the card to
fasten the card in place.
Malfunctions or incorrect operation may occur if the card
is not fastened.
NOTE
When connecting unbalanced cables to the [INPUT]
connector, use a jumper wire to connect the “-” and “G”
of the Euroblock.
+
–
G
Slot cover
NOTICE
When inserting the card, align both sides of the
card with the guide rails in the slot of the host
device.
CAUTION
Before connecting a separately sold Mini-YGDAI I/O
card to the MTX5-D, you must turn off the power
switches for the MTX5-D. Failure to observe this will
cause malfunction or electric shock.
Card