User Manual
Table Of Contents
Quick Guide
MTX5-D Owner’s Manual
18
8. Make DCP settings.
Assign the parameters of the MTX5-D to the switches and
knobs of the connected DCP units. Here you can also spec-
ify the brightness of the DCP’s LEDs. For details on how to
make DCP settings, refer to “MTX-MRX Editor User
Guide.”
9. As necessary, make settings for devices
other than the MTX5-D.
For details, refer to “MTX Setup Manual.”
10.
Specify and store a preset.
You can use presets to change the volume of zones and the
audio source to play (e.g., SD memory card or CD player)
in a single action. To prevent problems such as a sudden
increase in volume when the MTX5-D is operated, we rec-
ommend that you store the preset with the output level low-
ered to “-infinity (
).” For details on presets and how to
recall them, refer to “Recalling (switching) presets” on
page 20, and “MTX-MRX Editor User Guide.”
11.
Save your settings and close MTX-MRX Edi-
tor.
A project file with the extension “.mtx” will be created.
Install and connect the system while referring to the schematic
diagram you printed out.
1. Install the MTX5-D, and make the analog
audio connections.
2. Make digital connections between the MTX5-D
and any XMV/EXi8/EXo8.
Make a ring connection with the devices equipped with a
[YDIF] connector.
3. Connect the MTX5-D and the Dante device
that supports the MTX5-D to the Dante net-
work.
For details on connections, refer to “About connections” on
page 15.
4. Connect the MTX5-D to an analog input amp.
5. Set the UNIT ID of the MTX5-D and the XMV/
EXi8/EXo8.
Set the UNIT ID for every MTX5-D and XMV/EXi8/EXo8
device you connected in the above steps. The UNIT ID is
specified by the combination of the [UNIT ID] rotary switch
and DIP switches located on each device’s rear panel. Set
each device to a different UNIT ID so that no conflict occurs.
6. Make connections between the MTX5-D and
the DCP units.
Daisy-chain the DCP units. Set the panel ID and termination
settings of the DCP units. For details, refer to the DCP
owner’s manual.
On-site work (Installation and wiring)