User Manual
Table Of Contents
- 0. Revision History
- 1. Setup
- 2. Command List
- 3. Command Specifications
- 4. Command Sequence
- 5. Meter Value
- 6. Parameter Value Details
- 6.1. Fader parameter
- 6.2. Other parameters (MTX3, MTX5-D)
- 6.3. Other parameters (MRX7-D)
- 7. Parameter List
- 8. Meter List
MTX3/MTX5-D/MRX7-D/XMV Series/EXi8/EXo8 Remote Control Protocol Speciîš¿cations V3.1.0 rev10
53
4. Command Sequence
Example when the controlled device starts earlier than the controller
OK devstatus runmode "normal"
Remote controller
Starting Device starting
Connection unknown
* With the first devstatus runmode
request, a result notification is
returned.
Controlled device
Connection detection
Connected physically
Device normal running
devstatus runmode
Controller can recognize that Controlled device is ready to receive commands when there is response for "devstatus runmode" command.
In case of Ethernet connection, Ethernet logical session (e.g. port open) should be established before sending "devstatus runmode".