User Manual

Table Of Contents

Menu bar

Yamaha LAN Monitor for Win User Guide

5 Power supply interruption time

Suspends the power supply when a disrupted or inactive connection is detected. Set the power supply

interruption time in seconds in case of interruption.

Setting range: 1 – 60 sec

Default: 5 sec

6 Preview size of the Whole map

Select the size of the preview image of the “Whole map” generated for print preview and printing.

If printing or previewing the “Whole map” has failed, the failure may be avoided by setting the preview size to A6.

7 Snapshot function

• “Treat equipment as comparison for snapshots” check box:

Clear this check box to exclude devices as targets for comparisons.

Default: Selected

8 [OK] button

Applies the configured settings.

NOTE

• The [OK] button is only available when acceptable input values have been input.

• Click the [OK] button to reset the monitoring timer and begin counting from 0 seconds again.

9 [Cancel] button

Closes the dialog box without applying setting changes.

 [VLAN registration]

Open the “VLAN registration” dialog box.

The VLAN you register here will be used when configuring the tagged VLAN for the switch.

Also, as the registered VLAN information is recorded in the label settings file, you can export the file from the

“Export Label Settings” in the Setup menu.

1 List of registered VLAN

Displays the list of the VLAN registered with the Yamaha LAN Monitor.

“VLAN ID:1” is registered as the default VLAN and cannot be changed.

2 “Register number” input area

Input the VLAN registration number here.

This number is used when configuring a tagged VLAN only on the SWX2200 series.

If you are not using the SWX2200 series, this number is only used as the ID number on the Yamaha LAN

Monitor, and has no relation to the switch’s VLAN settings.

From two to 255 single-byte characters can be used for this value.

You cannot set the same number twice.

❼❽

4 ❻