User Manual

Configuring the device
Yamaha LAN Monitor for Win User Guide
35
Configuring the device
With Yamaha LAN Monitor, you can configure some of the functions for Yamaha switches and Yamaha wireless LAN
access points.
There are the following three methods for setting the device.
“Device Settings” dialog
The “Device Settings” dialog can be displayed in the following two ways.
Either way, the same dialog will be displayed.
• Map screen - “Device Details” view - “Device Settings” button
• List screen - “Switch / Wireless AP List” tab - “Setting” button
The setting items displayed in the dialog vary from model to model.
 For non-SWX2110/SWX2110P/SWX2200 series Yamaha switch and Yamaha wireless LAN
access point
Basic items such as label settings, device name settings, and IP address settings can be configured.
Only items that are supported by the device will be displayed.
Setting method Descriptions
“Device Settings” dialog
(page 35)
You can set basic items such as IP address and device name.
For models without a Web GUI, a detailed setting dialog will be displayed.
Web GUI (page 39)
Using the device's Web GUI, detailed settings for each function can be made.
To access the Web GUI of the device, the IP address must be set appropriately in the
“Device Settings” dialog, and IP communication must be maintained between the PC
running Yamaha LAN Monitor and the device to be operated.
CONFIG import (page 33)
By importing a backup or pre-prepared CONFIG, you can apply the settings for each
function all at once.
[Include in a snapshot]
check box
Turns the snapshot function on/off for each device. For a slave device, this is fixed on.
This item will be displayed for all devices.
“Label Settings”
You can enter any label or comments you like to identify each device.
Since the labels and comments you set will only be used within LAN Monitor, this
information can be associated with the device without changing the settings of the device
itself.
This item will be displayed for all devices.