User Manual

Table Of Contents
Network settings on the computer
Yamaha LAN Monitor for Win User Guide
9
Network settings on the computer
Configure network settings for your computer.
1. Connect the computer to a network device.
2. Start Yamaha LAN Monitor.
NOTE
If the “User Account Control” dialog box appears, click [Yes].
3. Click the [Setup] menu on the menu bar [Open IP Settings for PC].
The “Network Connections” window appears.
4. Right-click the network adapter to which the network device is connected, and click
[Properties].
The “Ethernet Properties” dialog box appears.
5. Select [Internet Protocol Version 4 (TCP/IPv4)], and click [Properties].
The “Internet Protocol Version 4 (TCP/IPv4) Properties” dialog box appears.
NOTE
If the [Internet Protocol Version 4 (TCP/IPv4)] check box is not selected, make sure to select it.
6. Set your IP address.
7. Click [OK].
8. Close the “Ethernet Properties” dialog box and the “Network Connections” window.
NOTE
In some cases, the Windows firewall might block Yamaha LAN Monitor. Select the [Private networks] check box, and click
[Allow access].
If the network is configured using DHCP
Select [Obtain an IP address automatically].
If a static IP address is set for each device
Select [Use the following IP address] and enter
an address.