User Manual
Table Of Contents
- Yamaha LAN Monitor for Win
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Win
1.4. Software operating requirements
OS
Windows 7, Windows 8.1, Windows 10, Windows 11
(For Windows 7, 8.1, 10, both 32-bit and 64-bit editions are supported.)
CPU
32 bit: 2 GHz or faster Intel Core/Pentium/Celeron family processor
64 bit: Processor that supports Intel64 (however, the program runs in 32-bit
operation).
Storage 200 MB or more free space (not including the Dante Controller)
Display Resolution: 1280 x 768 or higher
Other
Mouse or other pointing device
Ethernet (This will not work via wireless LAN.)
NOTE
The operating requirements listed above are for Yamaha LAN Monitor version 1.8.6.
Refer to the following URL for the latest information on the current version of the
software and operating requirements.
http://www.yamaha.com/products/en/network/
https://www.yamahaproaudio.com/
Depending on the computer you’re using, the operating requirements might be greater
than listed above.
Important
This software requires one or more L2MS-compatible Yamaha switches or Yamaha
wireless LAN access points to be found on the network.
Note that this software will not function until an L2MS-compatible Yamaha switch
or Yamaha wireless LAN access point is found.
1.5. Notes
Notes regarding device detection
• Switches made by another manufacturer and agents and devices that are subordinate to a router
made by another manufacturer cannot be shown correctly.
• Devices that are connected to a switch made by another manufacturer are shown as devices
connected to the immediately previous agent. However, depending on the structure of the
network, it might not be possible to show them.
• Do not connect any L2MS managers other than Yamaha LAN Monitor on the network. Also, only
one Yamaha LAN Monitor can be used in the same network.
• Connect Yamaha LAN Monitor directly to the agent. If there is a device other than the agent
between Yamaha LAN Monitor and the agent, the terminal or agent may not be recognized
correctly.
Notes regarding SWX2100/SWR2100P series PoE switch detection
When an SWX2100/SWR2100P series PoE switch is detected, power will also be supplied to PoE
receiving devices connected to ports not configured to supply power.
Notes regarding the power supply interruption function for the Yamaha PoE switch
Turn off the power supply interruption function for the Yamaha PoE switch when updating the
firmware version of a PoE receiving device which is supplied power from the Yamaha PoE switch.
1. Introduction
6 | Yamaha LAN Monitor for Win User Guide