User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
Menu bar
MRX Designer User Guide
14
[View]
[Components]
If this item has a check mark, the corresponding
area is shown.
—
[Parameter
Sets]
—
[Parameter
Link Group]
—
[Gang Edit
Group]
—
[Properties] —
[Parameters] —
[Bird’s Eye
View]
Selects the Bird’s Eye view display type.
[Floating] : Shows the Bird’s Eye view in a
separate window from MRX
Designer.
[Docking] : Shows the Bird’s Eye view in the
lower right of MRX Designer.
[Hide] : Hides the Bird’s Eye view.
—
[Zoom In] Magnifies the display within the design sheet. —
[Zoom Out] Shrinks the display within the design sheet. —
[Zoom to
100%]
Sets the display magnification in the design
sheet to 100%
—
[Zoom to Fit]
Adjusts the magnification so that all placed
components can be seen in the design sheet.
—
[Print Aria]
On the design sheet, shows the paper size
specified in the “Print” dialog box. The (x,y)=(0,0)
of the design sheet is the top left of the paper.
—
[Tools]
[Compile]
Analyzes the placement and wiring of the
components in the selected MTX/MRX system to
see whether there are any problems.
“Compile” dialog box
[Snapshot
Group]
Specifies a snapshot group.
“Snapshot Group” dialog
box
[Remote
Control Setup
List]
Registers the parameters that will be controlled
from a remote controller.
“Remote Control Setup
List” dialog box
[Peak Hold]
If ON is checked, the meters of the assigned
component will hold the maximum value.
If you select Reset, the held maximum value is
reset.
—
[Trace Signal
Path]
If you select a port or wire while this is checked,
the signal path is traced toward the output and
toward the input, starting from the selected item.
—
[Duplicate Port
Label]
If you make a connection while this is checked,
the port name of the connection-source is copied
to the connection-destination port.
—
Menu Command Summary
Dialog box or window
that appears