User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
“Gang Edit Group” area
MRX Designer User Guide
40
1 [Active] button
Enables/disables the gang edit group function. This applies to the currently selected
group.
2 [New] button
Creates a new gang edit group.
3 [Delete] button
Deletes the selected gang edit group or component.
4 [+]/[?] buttons
Completely expands or completely minimizes the gang edit group display.
5 [Parameters] check box
Select the check box for parameters that you want to link.
The actual procedure is described below.
1. Click the [New] button.
2. Enter a gang edit group name, and click the [OK] button.
3. Drag and drop a component from the design sheet while holding down
<Ctrl>, or from the “Parameters” area.
4. Clear the check box of parameters that you don’t want to link.
5. Click the [Active] button or the [Gang Edit] button located in the tool
buttons.
6. Select the gang edit group that you want to link.
7. Double-click a component in the design sheet associated with the
selected gang edit group.
8. Use the component editor to edit the parameter.
Parameters of the same type of components that are associated with the gang edit
group will change in tandem.
9. Click the [Active] button or the [Gang Edit] button located in the tool
buttons.
This specifies the unlinked state.
When MTX-MRX Editor is online, and [Active] is on, operating an external controller will modify
the linked parameters.
NOTE