Setup Instructions

Example 4) A system using Dante
MTX Setup Manual
81
Using the Device Configuration Wizard to create your device setup
You will use MTX Editor’s wizard to create your device setup before actually connecting your equipment.
After you’ve made basic settings, you’ll be able to print information about system cabling and ID numbers.
Make basic settings for System A, and then make basic settings for System B.
Use the following procedure to make basic settings.
1.
Enter a name for the MTX system that we are calling System A, and then click [NEXT>].
2.
Specify the number of units that will be connected in your MTX system, and click [Next>].
In “YDIF Connected,” specify 1 each as the number of MTX5-D, EXi8, and EXo8 devices.
To make settings for the EXo8, use the scroll bar to make the EXo8 visible.