Setup Instructions

Example 4) A system using Dante
MTX Setup Manual
89
Make the following settings.
17.
When you have finished setting the [UNIT ID] rotary switch and DIP switch of the devices,
click [Next>].
MTX5-D
UNIT ID = 04
[UNIT ID] rotary switch = 4
DIP switches are all OFF (upward)
XMV4280
UNIT ID = 30
[UNIT ID] rotary switch = 0
DIP switch 1 and 2 are ON (downward), others are OFF
(upward)
XMV4280-D
UNIT ID = 31
[UNIT ID] rotary switch [HIGH] = 3
[UNIT ID] rotary switch [LOW] = 1
NOTE
On the XMV4280, the higher digit of the UNIT ID is set by the DIP switch, and the lower digit is set by the [UNIT ID] rotary switch.
For details, refer to the owner’s manual of each device.
[HIGH]
[LOW]
UNIT ID = 3 0
Lower digit: specify using the rotary switch
Upper digit: specify using DIP switch 1–3