Owner's Manual

MTX3 Owner’s Manual
9
Controls and Connectors
q SD memory card slot
You can insert an SD memory card here. Music or sound
effects can be played back from an SD memory card contain-
ing audio files (MP3 files and WAV files). Before you insert
an SD memory card into the slot, or remove an SD memory
card from the slot, remove the slot cover.
For details on SD memory card handling, refer to page 19.
For details on how to play back audio files, refer to the
MTX-MRX Editor User Guide.
w [INPUT PEAK] indicators 1–8
These indicators will light red when the input level of the
corresponding INPUT channel is -3 dBFS or higher.
e [INPUT SIGNAL] indicators 1–8
These indicators will light green when the input level of the
corresponding INPUT channel is -40 dBFS or higher.
r [OUTPUT SIGNAL] indicators 1–8
These indicators will light green when the output level of the
corresponding OUTPUT channel is -40 dBFS or higher.
t [PRESET] display
This display usually shows the preset number. It can also
show the UNIT ID, alert number, or a message.
y [s]/[t] buttons
Use these buttons to change the preset number or alert num-
ber shown in the above [PRESET] display.
u [ENTER] button
Use this button to confirm the item shown in the above
[PRESET] display.
When an alert number is shown, pressing this button will
return to the preset number display.
i [ALERT] indicator
When an alert occurs, the [PRESET] display will indicate
the alert number and this indicator will flash red.
o [POWER] indicator
This indicator will light when this device is powered-on.
!0 [NETWORK] indicator
This indicator will light green if a link is established with an
external device via the rear panel NETWORK connector
(page 10). It will flash while data is being sent or received.
!1 [YDIF] indicator
This indicator will light green if the rear panel [YDIF IN]
connector (page 11) is correctly connected to the [YDIF
OUT] connector of another device.
!2 [SCHEDULER] indicator
This indicator will light yellow if an even has been specified
in the scheduler (page 17), and will start flashing one minute
before the event.
!3 [SD/ACT] indicator
This indicator will light yellow if an SD memory card is
inserted in the SD memory card slot (q) and has been
detected correctly. It will flash while the SD memory card is
being accessed.
!4 Power switch
This is the power switch. The power is on if the switch is in
the position. The power is off if the switch is in the
position.
Front Panel
88
q y u i o !4!0
!1 !2 !3
we t
r
NOTE
• Do not cycle the power switch in rapid succession. Wait at
least 6 seconds before turning the power switch on after it
has been turned off. Failing to observe this precaution
may cause malfunctions.
• Even when the power switch is turned off, a small amount
of current is flowing through the unit. If you plan not to use
the unit for a long period of time, remove the power cable
from the AC outlet.