manual

“XMV” screen Chapter 4. System screen

MTX Editor User’s Manual

112

“XMV” screen

Here you can view and edit the parameters of the XMV units in the MTX system. The units are

grouped according to how they are connected: YDIF-connected, analog-connected, or Dante-

connected. When you right-click on the display area of a desired XMV, a context menu appears,

allowing you to copy and paste settings between devices.

If digital connections and analog connections coexist, we recommend that you set the XMV’s input sensitivity

to [–20 dBFS] in the [Device] tab of the Project screen. If this is set to [–20 dBFS], the digital connections and

analog connections will have the same input sensitivity.

1 [EDIT] button

This button enables the input routing select buttons for YDIF-connected and Dante-

connected XMV units.

The [EDIT] button is available only in the offline state.

2 [Preserve the Dante settings configured by Dante Controller]

check box

Select this check box if you’re using Audinate Corporation’s Dante Controller to set up

the Dante network. The settings of Dante Controller will take priority over the settings

made in MTX Editor.

3 [ALL STANDBY]

If you click the [STANDBY] button, the power of all XMV units in the MTX system will

be switched to standby. If you click the [ON] button, the power of all XMV units in the

MTX system will be turned on.

4 [ALL MUTE]

If you click the [OFF] button, mute will be defeated for all XMV units in the MTX

system. If you click the [ON] button, all XMV units in the MTX system will be muted.

NOTE