manual

“GPI Calibration” dialog box Chapter 7. Dialog boxes
MTX Editor User’s Manual
171
❑ “GPI Calibration” dialog box
Here you can calibrate the input voltage detection range for the [GPI] connector of the MTX unit.
(Available only when online.) These settings adjust the detection range in order to stabilize the
input voltage of the [GPI] connector.
● [Device:] box
Selects an MTX unit within the MTX system.
From the left, this shows the “UNIT ID,” “Type (model name of the device),” and
“Device Name (name of the device).”
● Channel select check boxes
Calibration will be applied to the channels whose boxes are selected.
● [All Ports] check box
Selects the check boxes of all channels.
● Calibration data
The input voltage is shown in real time as a graph.
● [Reset] button
Calibration will be reset for the channels whose boxes are selected.
● [Max] button
Sets the current input voltage of the selected channels to the maximum value.
The maximum value you set is shown by a red bar.
● [Min] button
Sets the current input voltage of the selected channels to the minimum value.
The minimum value you set is shown by a blue bar.
● [Close] button
Closes the dialog box.