manual
Terms used in this user’s manual Chapter 1. An overview of MTX Editor
MTX Editor User’s Manual
5
● Emergency mode
If the “Preset” dialog box’s [Emergency Recall] setting is [ON], the MTX will enter this
mode when it receives an EMG (Emergency) signal from an external device, or when
the input to the +24V [GPI IN] pin (IN 8 for the MTX3, or IN 16 for the MTX5-D) falls
below 2.5V. In this mode, the unit will operate as follows.
• The current state will be remembered. This remembered state is used to return to the
original state when the unit exits Emergency mode.
• The preset specified by the “Preset” dialog box’s [Emergency Recall] setting will be
recalled.
• Operations from an external controller such as a DCP will no longer be received.
• The unit will be taken offline from MTX Editor.
• All MTX units in the same MTX system will enter Emergency mode.