User Guide

29
MIDI Data Format
Hold1 0 (off)
Portamento 0 (off)
Sostenuto 0 (off)
Soft Pedal 0 (off)
Portamento Control cancels the Portamento Source
Key Number that was received.
RPN number not specified; internal
data will not change.
NRPN number not specified; internal
data will not change.
1.2.23.3 All Notes Off
Terminates all notes currently on for the specified
channel. However, if Hold1 or Sostenuto is on,
notes will continue sounding until these are turned
off.
1.2.23.4 Omni Off
Performs the same function as when an All Notes
Off message is received.
1.2.23.5 Omni On
Performs the same function as when an All Notes
Off message is received.
1.2.23.6 Mono
Performs the same function as when an All Sounds
Off message is received, and if the 3rd byte (mono
number) is in the range of 0-16, sets the corre-
sponding channel to Mono Mode (Mode 4 : m =
1).
1.2.23.7 Poly
Performs the same function as when an All Sounds
Off message is received, and sets the corresponding
channel to Poly Mode (Mode 3).
1.3 Program Change
Messages for Voice selection.
With a combination of Bank Select, you can select not
only basic Voice numbers, but also variation Voice
bank numbers.
If the Multi Part parameter Rcv PROGRAM
CHANGE (Table 1-4) = OFF, that Part will not
receive Program Change messages.
1.4 Pitch Bend
Messages for pitch bend wheel values.
If the Multi Part parameter Rcv PITCH BEND
CHANGE (Table 1-4) = OFF, that Part will not
receive Pitch Bend messages.
1.5 Channel Aftertouch
Messages which let you control various functions by
the pressure you apply to the keys after the initial
striking of the keys, over the entire channel.
If the Multi Part parameter Rcv CHANNEL AFTER
TOUCH (Table 1-4) = OFF, that Part will not receive
Channel Aftertouch.
1.6 Polyphonic Aftertouch
Messages which let you control various functions by
the pressure you apply to the keys after the initial
striking of the keys, for each individual key.
If the Multi Part parameter Rcv POLYPHONIC
AFTER TOUCH (Table 1-4) = OFF, that Part will not
receive Polyphonic Aftertouch. Effective range is
between note numbers 36-97.
2. SYSTEM EXCLUSIVE MESSAGES
System Exclusive messages control various functions
of the MU10, including master volume and master
tuning, play mode, effect type and various other
parameters.
* The device number of the MU10 is fixed to “All”.
2.1 Parameter Change
The MU10 receives the following parameter change
messages.
[ UNIVERSAL REALTIME MESSAGE ]
1) Master Volume
[ UNIVERSAL NON REALTIME MESSAGE ]
1) General MIDI Mode On
[ XG NATIVE PARAMETER CHANGE ]
1) XG System on
2) XG System Data parameter change
3) Multi Effect1 Data parameter change
4) Multi Part Data parameter change
5) A/D Part Data parameter change
6) A/D System Data parameter change
7) Drums Setup Data parameter change
[ MU10 NATIVE PARAMETER CHANGE ]
1) MU10 System Data parameter change
[ OTHER ]
1) Master tuning
2) TG300 System Data parameter change
3) TG300 Multi Effect Data parameter change
4) TG300 Multi Part Data parameter change
2.1.2 Universal Realtime Messages
2.1.2.1 Master Volume
11110000 F0 Exclusive status
01111111 7F Universal Real Time
01111111 7F ID of target device
00000100 04 Sub-ID #1=Device Control
Message
00000001 01 Sub-ID #2=Master Volume
0sssssss ss* Volume LSB