User Manual



 
3n pp 00 1 00 - 7F PROGRAM NUMBER 1...128
depends on performance
number
3n pp 01 1 00 - 7F BANK SELECT 0...127 (XG voice map 参照 ) 〃
3n pp 02 1 00 - 7F VOLUME 0...127 〃
3n pp 03 1 00,01-7F PAN RND,L63...C...R63 〃
3n pp 04 1 00 - 7F DRY SEND LEVEL 0...127 〃
3n pp 05 1 00 - 7F CHORUS SEND 0...127 〃
3n pp 06 1 00 - 7F REVERB SEND 0...127 〃
3n pp 07 1 00 - 7F VARIATION SEND 0...127 〃
3n pp 08 1 28 - 58 NOTE SHIFT -24...0...+24[semitones] 〃
3n pp 09 1 00 - 7F
LOW PASS FILTER CUTOFF FREQUENCY
-64...0...+63 〃
3n pp 0A 1 00 - 7F LOW PASS FILTER RESONANCE -64...0...+63 〃
3n pp 0B 1 00 - 7F EG ATTACK TIME -64...0...+63 〃
3n pp 0C 1 00 - 7F EG DECAY TIME -64...0...+63 〃
3n pp 0D 1 00 - 7F EG RELEASE TIME -64...0...+63 〃
3n pp 0E 1 00 - 7F VIBRATO RATE -64...0...+63 〃
3n pp 0F 1 00 - 7F VIBRATO DEPTH -64...0...+63 〃
3n pp 10 1 00 - 7F VIBRATO DELAY -64...0...+63 〃
3n pp 11 2 00 - 0F DETUNE -12.8...0...+12.7[Hz] 〃
3n pp 11 00 - 0F 1st bit3-0 → bit7-4
2nd bit3-0 → bit3-0
RcvNOTE MESSAGE 1st bit6 : OFF,ON(0,1)
MONO/POLY MODE 1st bit5 : MONO,POLY(0,1)
PORTAMENTO SWITCH ＊ "1st bit4 : OFF,ON(0,1)
3n pp 13 1 00 - 7F PITCH EG INITIAL LEVEL 0...127 〃
3n pp 14 1 00 - 7F PITCH EG ATTACK TIME 0...127 〃
3n pp 15 1 00 - 7F PITCH EG RELEASE LEVEL 0...127 〃
3n pp 16 1 00 - 7F PITCH EG RELEASE TIME 0...127 〃
3n pp 17 1 00 - 7F MW LFO PMOD DEPTH ＊ 0...127 〃
3n pp 18 1 00 - 7F MW LFO FMOD DEPTH ＊ 0...127 〃
3n pp 19 1 28 - 58 PITCH BEND CONTROL ＊ -24...0...+24[semitones] 〃
3n pp 1A 1 00 - 7F
AC1 LOW PASS FILTER CONTROL
＊ -64...0...63 〃
3n pp 1B 1 00 - 7F AC1 AMPLITUDE CONTROL ＊ -100...0...+100[%] 〃
3n pp 1C 1 00 - 7F VELOCITY SENSE DEPTH 0...127 〃
3n pp 1D 1 00 - 7F VELOCITY SENSE OFFSET 0...127 〃
3n pp 1E 1 00 - 7F NOTE LIMIT LOW C-2...G8 〃
3n pp 1F 1 00 - 7F NOTE LIMIT HIGH C-2...G8 〃
3n pp 20 1 00 - 7F PORTAMENTO TIME ＊ 0...127 〃
3n pp 21 1 01 - 7F VELOCITY LIMIT LOW 1...127 〃
3n pp 22 1 01 - 7F VELOCITY LIMIT HIGH 1...127 〃
TOTAL SIZE 23
n: performance part number (01-04)
pp:performance number (00-63)
＊印のパラメーターは、n=1 のデータのみを Common data として受信し、n=2 ∼ 4 のデータは受信しない。