Tone Generator Owner's Manual

MU 128 Guided Tour
87
English
On Your Own...
While you’re at it, try making some of your own settings. The procedure is
the same:
1) Select the desired Part and Voice.
2) Call up the Edit menus by pressing the [EDIT] button.
3) Select “OTHERS” with the [SELECT </>] buttons, then press
[ENTER].
4) Set the Assignable Controller number for the Part.
5) Select the appropriate parameters with the [SELECT </>] buttons.
If you are using the AC1 Filter Control, make sure to appropriately set
other filter settings. (in “FILTER” parameters, page 111, and/or “DRUM”
parameters, page 126.)
Select the AC1 parameters in the “OTHERS” parameters. (In the
Performance mode, these are in the “COMMON” parameters; see page
137.)
If you are using a Drum Part, select the desired drum sound, either by
playing the corresponding key or by using the [PART -/+] buttons.
6) Change the value, with the [VALUE -/+] buttons or data dial.
7) Use the [EDIT] button as needed to return to the Edit menu.
Assignable Controller (AC1)