Tone Generator Owner's Manual

MULTI MODE

Range: –12.8 … +12.7

Default: 0.0

This determines the fine tuning of the Part’s Voice.

HINT

Detune could be used to slightly detune a Voice compared to the tuning of the rest of the

Voices for a richer sound. It could also be used to detune two different Voices being played

in unison. For example if two different Parts are set to the same MIDI channel (see page 37)

and same Voice, a naturally thick chorusing effect can be obtained by slightly detuning each

Voice in opposite directions here.

Part Mode

Selected Part and MIDI channel

Height of bars indicates selected Part Mode setting for each Part. (A

single bar indicates “normal” setting.)

Settings: normal, drum, drumS1 … S4

Default: normal (Parts 1 … 9, 11 … 25, 27 … 32)

drumS1 (Part 10)

drumS3 (Part 26)

(When Sound Module mode is set to C/M, both Parts 10 and 26 are set

to drumS1.)

This determines the mode for the Part. A setting of normal allows selec-

tion of the normal instrument Voices. (See the SOUND LIST & MIDI

DATA booklet.) The drum setting allows selection of the drum kits. (See

the SOUND LIST & MIDI DATA booklet.) The drumS1 … S4 settings

are locations for storing specially programmed drum setups. These setups

can be edited by using the Drum Setup controls in the Multi Edit mode.

(See page 61.) The drum and drumS1 … S4 settings are not available in

the Performance mode.

The Part Mode settings differ depending on the Sound Module mode

selected, as described below.

For XG (Extended General MIDI) mode:

All settings described above are available. When normal is selected,

any of the basic or the extended set of Voices can be used for the Part.