User Manual

Information for qualified contractors or dealers

Mounting the unit on a wall

Mount the unit on a wall so that the touch panel faces forward.

CAUTION

▪ To prevent the unit from falling, attach it to a wall constructed of drywall

(plasterboard).

▪ Make sure you use screws (sold separately) that can support the weight of the

installation. Using clamps other than specified screws, such as short screws,

nails, and two-sided tape, may cause the unit to fall.

▪ Fix the cables in place where they will not become loose. If your foot or hand

accidentally gets caught on a loose cable, the unit may fall.

▪ Do not lean on the unit or apply excessive force to the top of the unit. Doing so

may cause the unit to fall.

▪ Check that the unit is fixed securely after the installation. Yamaha will bear no

responsibility for any accidents caused by improper installations.

Attach the mounting template (supplied) on a wall

and mark for the screw holes.

DRILL HERE / PERCER CIC

MOUNTING TEMPLATE / GABARIT DE FIXATION

DRILL HERE / PERCER CIC

Tapes or thumbtacks

Mounting template (supplied)

Screw holes

Remove the mounting template from the wall, and

then install screws (sold separately) at the points

marked on the wall.

7 to 9 mm

(1/4" to 3/8")

13 to 15 mm

(1/2" to 5/8")

4 to 5 mm

(#8 to #10)

20 mm (3/4")

or more

457 mm

(18")