User Manual

CONNECTIONS
5 En
Make sure to connect L (left) to L, R (right) to R, “+” to “+” and “–” to “–.” If the connections are faulty, no sound may be heard from the speakers, and if the polarity of the
speaker connections is incorrect, the sound may be unnatural and lack bass. Refer to the owner’s manual for each of your components. Make sure to use RCA type cables, the supplied
system connection cable, or a commercially available USB cables (A-U670 only) to connect audio components.
Do not connect this unit or other components to the main power until all connections between components are complete.
As shown in the figure, connect the ANALOG OUT jacks of the network CD player (CD-
NT670/CD-NT670D) to the ANALOG IN jacks of the unit by using the RCA stereo cable
supplied with the network CD player, and connect the SYSTEM jacks of the both
equipment to each other by using the supplied system connection cable.
When the SYSTEM jacks of the unit and the network CD player are connected to each
other, you can use the remote control of the network CD player to operate the unit
(☞page 10).
Connect the SPEAKERS terminals of the unit and the terminals of the speakers as shown
in the figure.
CONNECTIONS
CAUTION
Connecting a network CD player Connecting speakers