User Manual
En 131
Configure the system settings of the unit while viewing the front display.
1
Set the unit to standby mode.
2
While holding down STRAIGHT on the front panel, press MAIN ZONE
z
.
3
Press PROGRAM to select an item.
4
Press STRAIGHT to select a setting.
5
Press MAIN ZONE z to set the unit to standby mode and turn it on
again.
The new settings take effect.
ADVANCED SETUP menu items
• Default settings are underlined.
Changing the speaker impedance setting (SPEAKER IMP.)
Change the unit’s speaker impedance settings depending on the impedance of the
speakers connected.
Settings
Configuring the system settings
(ADVANCED SETUP menu)
MAIN ZONE z STRAIGHT
PROGRAM
Item Function Page
SPEAKER IMP. Changes the speaker impedance setting. 131
REMOTE SENSOR Turns on/off of the remote control sensor on the main unit. 132
REMOTE CON AMP Selects the unit’s remote control ID. 132
TUNER FRQ STEP
(Asia and General models only)
Changes the FM/AM tuning frequency setting.
132
TV FORMAT Switches the video signal type. 132
MONITOR CHECK Removes the limitation on HDMI video output. 133
4K MODE Selects the HDMI 4K (60 Hz/50 Hz) signal format. 133
RECOV./BACKUP
Creates backup of the settings of the unit, or recovers the settings
from the backup.
133
INITIALIZE Restores the default settings. 133
FIRM UPDATE Updates the firmware. 134
VERSION Checks the version of firmware currently installed on the unit. 134
6 MIN
Select this option when you connect 6-ohm speakers to the unit. You
can also use 4-ohm speakers as the front speakers.
8
MIN
Select this option when you connect 8-ohm or higher speakers to the
unit.
OUT
1
IN
OUT
2
VOLUME
MUTE
DRCADAPTIVE
3
ZONE
2
SBLPL SBRSB PR
SW1
SL
SW2SW
SR
PL
CL R
PR
STEREO
ENHANCER
SLEEP
HD
TUNED
PRE
AMP
PAR TY
ZONE
3
ZONE
4
HD
TAG
DOCK
¡¡¡¡¡¡¡¡¡8¬MIN
¡SPEAKER¡IMP.