User Manual
Selecting the HDMI 4K signal format (4K MODE)
ENHANCER
LINK
ECO
MASTER
OUT
2
-
R
es
Hi
YPAO
VOL.
A
-
DRC
SLEEP
STEREO
PARTY
TUNED
ZONE
3 B2 A
VOL .
FPR
SL
SW
SR
SBL SB SBR
FPL
MUT E VIRTU AL
4K MODE•MODE 1
Selects the format of signals input/output at the unit when HDMI 4K compatible TV and
playback device are connected to the unit.
ADVANCED SETUP menu
“4K MODE”
Settings
MODE 1
Inputs/outputs 4K signals shown in the following table. Depending on the
connected device or HDMI cables, video may not be displayed correctly.
In this case, select “MODE 2”.
MODE 2 Inputs/outputs 4K signals shown in the following table.
NOTE
When “MODE 1” is selected, use a Premium High Speed HDMI Cable or Premium High Speed Cable with
Ethernet.
Format
MODE 1 MODE 2
8 bit 10 bit 12 bit 8 bit 10 bit 12 bit
4K/60, 50 Hz
RGB 4:4:4
4
– –
YCbCr 4:4:4
4
– –
YCbCr 4:2:2
4
–
YCbCr 4:2:0
4 4
–
4K/30, 25, 24 Hz
RGB 4:4:4
4 4
–
YCbCr 4:4:4
4 4
–
YCbCr 4:2:2
4 4
Backuping and restoring all the settings (BKUP/RSTR)
ENHANCER
LINK
ECO
MASTER
OUT
2
-
R
es
Hi
YPAO
VOL.
A
-
DRC
SLEEP
STEREO
PARTY
TUNED
ZONE
3 B2 A
VOL .
FPR
SL
SW
SR
SBL SB SBR
FPL
MUT E VIRTU AL
BKUP/RSTR•BKUP
Backups and restores all the unit's setting to a USB memory device. Prepare a USB
memory device using FAT16 or FAT32 format in advance.
ADVANCED SETUP menu
“BKUP/RSTR”
Settings
RSTR Restores all the previous backuped settings.
BKUP Backups all the settings.
1
Connect the USB memory device to the USB jack on the front
panel.
2
To start the process, press STRAIGHT to select “BKUP” or
“RSTR” and then press INFO on the front panel.
3
Press INFO again after the confirmation message appears on the
front display.
4
When “Complete” appears on the front display, press z (power)
to set the unit to standby mode and turn it on again.
If “Failed” appears on the front display, check the following and start the
process again.
En
119