User Manual

PLAYBACK ➤ Wireless playback of audio via Bluetooth connection En 48
Listening to music from a Bluetooth device (Receiving)
1
Press the key on the remote control.
Bluetooth is selected as an input source, and
“BLUETOOTH” is shown in the front panel display.
• If a Bluetooth device has been connected before, the unit will connect to the
last connected device when the key is pressed. Terminate this
connection to connect a new device.
2
Turn on the Bluetooth function on the Bluetooth
device.
The operation varies depending on the device. Refer to
documentation supplied with the device.
3
Select “YSP-2700”* in the Bluetooth device list on
the device.
* If the unit is registered as a MusicCast-enabled device (p. 50), the
room name (network name) is displayed.
If a passkey (PIN) is required, enter the number “0000”.
The indicator in the front panel display flashes while the
unit and Bluetooth device are being connected, and glows
steadily when the connection is established.
“Connect” is shown in the front panel display.
The indicator or a completion message is displayed on
the Bluetooth device.
4
Play back a song on the Bluetooth device.
• With some Bluetooth devices, this unit must be specified as the destination for
audio output.
• Setting “Network Standby” in the setup menu to “On” allows the unit to be turned
on and off with Bluetooth device operations (p. 84).
Perform one of the following operations to terminate Bluetooth
connection.
The indicator on the unit’s front panel turns off when the
connection is terminated.
• Turn off the Bluetooth function on the Bluetooth device.
• Press the key for more than 3 seconds.
• Switch the unit's input source to any input source other than
Bluetooth.
• Turn off the unit.
• When Bluetooth connection is terminated, “Disconnect” is shown in the front panel
display.
BLUETOOTH
YSP-2700
PIN 0 0 0 0
123
456
7 8 9
0
Flashes while processing a
connection
Glows when the connection
is established
Terminating Bluetooth connection